44
Push down on the
base while pulling the
shoulder belt tightly to
remove all slack from
the lap portion of the
belt.
2
• If installing the convenience base with a vehicle seat belt,
return to page 25, Step 1.
• If installing the carrier (no convenience base) with a
vehicle seat belt, return to page 32, Step 3.
13 mm (0.5 in.)
4
5
Hold the lap and
shoulder belts together
just behind the free
sliding buckle
tongue and unbuckle
the seat belt.
While holding the belts
and buckle tongue,
thread the locking
clip onto the seat belt,
and slide it into place.
Note: Locking clip must
be placed within
13 mm (0.5 in.) of seat
belt buckle.
3
Buckle the seat belt
with the locking
clip in place.
Using the Locking Clip (cont.)
To Next Page
Loading...
