7. WARNING-Do not use electrical appliances inside the food storage compartments of the appliance unless they are of
the type recommended by the manufacturer.
8. Disconnect the power source from your refrigerator before carrying out user maintenance on it.
9.If a component part is damaged, it must be replaced by the manufacturer, its service agent, or similar qualified persons
in order to avoid a hazard.
10. Follow local regulations regarding disposal of your refrigerator due to flammable refrigerant and gas. All refrigeration
products contain refrigerants, which under the guidelines of federal law must be removed before disposal. It is the
consumer's responsibility to comply with federal and local regulations when disposing of this product.
11. Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
12. This appliance is intended to be used in the recreational vehicle.
13. When user cannot open the door at one side, please check if the other side of the door is fully closed. It is a
must that one side of the door is fully closed, then user is allowed to open the other side.
POWER SOURCE REQUIREMENT
This appliance is a Class III appliance, it must only be connected to a 12 volt circuit..
It should have a circuit breaker for full disconnection between the appliance and power supply mains.
Before use, the appliance should be disconnected from main power supply, and wiring connections should be
made according to the wiring diagram.
Do not connect the unit to an AC power supply.
For normal use, the connection to the power source connection must meet the following requirements:
14 AWG wire is not recommended. 13 AWG wire or larger is recommended.
This DC unit is not equipped with a power source. Please purchase a power
source from an authorized dealer.
1. When using an adaptor or converter AC to DC, No DC power supply is recommended.
2. It is recommended that only authorized or qualified professionals perform repair services on unit.
WIRE CONNECTION DIAGRAM
1. Connect ① terminal with Positive pole of 12V DC.
2. Connect ② terminal with Negative pole of 12V DC.
3. If the unit is installed in an RV, the ③GND terminal should be connected directly to the RV chassis..
To Next Page
Loading...
