Evercraft 776-3759 - Page 3

776-3759 3 06/04/12
WARNING
FAILURE TO OBSERVE THESE WARNINGS COULD RE SULT IN IN JU RY.
•Sprayedmaterialsmaybeharmfulifinhaled,
   orifthereiscontactwiththeskin.Adequate
   exhaustmustbeprovidedtokeeptheair
free of ac cu mu la tions of toxic ma te ri als.
   Useamaskorrespiratorwheneverthereis
   achanceofinhalingsprayedmaterials.The
   maskmustbecompatiblewiththematerial
   beingsprayedanditsconcentration.
IMPORTANT PRECAUTION INFORMATION - READ BEFORE
USING THIS SPRAY GUN:
SPRAY GUN DESCRIPTION
The776-3759isalightweight,anodizedaluminum,general
purposegravityfeedspraygundesignedforuseinvarioustypes
ofsprayingapplications.The776-3759canhandlewaterbased
andsolventbasedsprayingapplications.
IMPORTANT:Thisspraygunmaybeusedwithmostcommon
coatingandfinishingmaterials.Itisdesignedforusewithmildly
corrosiveandnon-abrasivematerials.Ifusedwithotherhigh
corrosiveorabrasivematerials,itmustbeexpectedthatfrequent
andthoroughcleaningwillberequiredandthenecessityfor
replacementofpartswillbeincreased.
HVLPMODEL776-3759
ThisHVLPspraygunwasmanufacturedtoprovidemaximum
transferefficiencybylimitingaircappressureto10psi(complies
withrulesissuedbySCAQMDandotherEPAairqualityauthorities).
ThisHVLPspraygunwillproduceapproximately10psicap
pressureat36-43psiguninletpressure,asmeasuredatthegun
inlet.Anaircaptestkitshouldbeusedtoinsure10psicap
pressure is not exceeded. OrdertestkitpartnumberRSTK59.
Formaximumtransferefficiency,donotusemorepressurethan
isnecessarytoatomizethematerialbeingapplied.
Connecttheguntoaclean,moistureandoilfreeairsupplyusing
ahosesizeofatleast5/16"I.D.hose.Donotuse1/4"I.D.hose.
(25'x1/4"hoseat18cfmhasapressurelossof25psi.25'x
5/16"hoseat18cfmhasapressurelossof8psi.)