EASY DECISION
12
ERROR CODES
If there is an error, error code will be showed at heater displays.
E1 : Cooling Fan is disabled, call authorized service agents.
E3 : Supply coltage is over than rated values, turn the hob off by touching ,wait
until “H” disappears for all zones, turn the hob on by touching and continue
to use. If same error is seems again, call authorized service agents.
E4: Supply frequency is different from rated values, turn the hob off by touching
, wait until “H” disappears for all zones, turn the hob on by touching
and continue to use. If same error is seem again, plug off/on turn the hob on by
touching continue to use it.İf same error is still seem call authorized service
agents.
E5: Hob inside temperature is too high, turn the hob off by touching let
heaters cool down.
E6: Communication error between touch control and heater, call authorized
service agents.
E7: Coil temperature sensor is disabled, call authorized service agents.
E8: Cooler temperature sensor is disabled, call authorized service agents.
E9: Calibration error, call authorized service agents.
To Next Page
Loading...
