EN
Assembly of the axle coupling (solid axle)
The coupling is always mounted on the left-hand side of the tractor wheel, as seen in the direction
of travel. It consists of two parts: the drawbar head, which is attached to the drawbar, and the axle
coupling, which is attached to the axle of the rear wheel hub of the towing bike. Before you mount
the axle coupling, you must determine whether your bicycle is suitable for towing a trailer. Check
the owner's manual of the bicycle, ask the manufacturer or ask a bicycle dealer.
can come loose while riding and lead to accidents with life-threatening injuries.
1. Unscrew the axle nut on the left side of the rear wheel counterclockwise.
Warning! Do not remove the lock washer (2). It prevents the rear wheel from twisting in the
dropouts. Riding without lock washers can lead to accidents with life-threatening injuries.
2. Place the axle coupling on the axle without removing the lock washer.
3.
wheel, which can lead to accidents with life-threatening injuries. The axle coupling must
Warning! Less than five full turns will not ensure sufficient clamping force of the rear
Warning! The rear wheel must be correctly fixed after mounting the axle coupling.An
4.
5. Finally, try to move the rear wheel in the dropouts to make sure it is correctly secured.
incorrectly fastened rear wheel can lead to accidents with life-threatening injuries when
riding. Observe the operating instructions for your towing bicycle. If in doubt, consult a
specialist workshop.
1.
To Next Page
Loading...