EN
Coupling the trailer to the bicycle
Warning! Check whether the towing bike is approved by the manufacturer for towing
trailers! Pulling trailers with an unsuitable towing bike can lead to frame fractures and
accidents with life-threatening injuries.
Coupling should always be done without a child in the trailer.
1. open the safety bar of the cotter pin. The cotter pin is located on the drawbar head and remove
the cotter pin.
2. Lift the drawbar and push the drawbar head onto the axle coupling mounted on the bicycle.
3. Put the cotter pin back into the hole provided on the drawbar head and close the safety bar.
Caution. Make sure that the connection is secure by pulling on the drawbar.
4. Pass the safety strap around the frame tube and hook the carabiner into the holder on the
drawbar. Make sure that the safety strap does not get caught in the spokes or disc brakes.
life-threatening injuries.
Warning! Never drive without securing the drawbar with the safety strap! If the trailer
Warning! Make sure that the axle coupling is correctly fixed in the drawbar head. If it is not
comes loose, it will still be connected to the bicycle. Failure to observe this can lead to
accidents with life-threatening injuries.
1.
2.
4.
To Next Page
Loading...