2.1 When you use a treadmill, the pressure on the running belt is unbalanced due
to the different forces used by the two feet during running, which causes the run-
ning belt to deviate from the center.
This kind of deviation is normal. When no one is running on the running belt, it will
return to the center. If it does not return to the center, you need to adjust the run-
ning belt back to the center.
2.2. How to adjust the running belt to the middle?
1) Run the treadmill without load and adjust the speed to 6KM/H.
2) Observe the distance from the running belt to the left and right side bars.
If it is to the left, use an Allen key and turn the screw on the left 1/4 turn clockwise;
If it is to the right, use an Allen key and turn the right screw 1/4 turn clockwise;
If the running belt is still not in the middle, repeat the above action until it is adjust-
ed to the middle.
3) After adjusting the running belt to the middle, adjust the speed to 1KM/H and
observe the deviation of the running belt and the smooth running. If there is a
deviation, repeat the running steps.
4) Warning! Do not over-tighten the roller! This will cause permanent bearing
damage!
If the above steps are not effective, you need to tighten the running belt again.
Special attention: The running belt is the most wear-prone part in operation.
Please replace it in time when the running wear is serious.
37 www.evolve-fitness.eu
To Next Page
Loading...