EVS XS - RCTL Board on SAS Disk Array

LEDs Function
The available LEDs on the XNet2CTL controller module are, from left to right:
LED Color Status Function
LED 1 Green On Ok.
Red On An error occurred while booting the H3X board.
LED 2 to
LED 8
— — For EVS internal use only.
FRAMER Green On The signal on the XNet2 IN connector is a valid EVS SDTI
signal.
NET Green On The XNet2 SDTI network is established (SDTI loop closed,
correct speed, etc).
DSP Green Blinking Indicates DSP activity (audio processing).
The available LEDs on the GBE Gigabit module module are, from left to right:
LED Color Status Function
CPU1
CPU2
Green Blinking These LEDs blink alternately every 250 milliseconds to
indicate that the processor is running.
Other
LEDs
— — For EVS internal use only.
Connectors
The following connectors are available on the XNet2 (SDTI) module:
J15 OUT connector for XNet2 (SDTI network 1485Mbps without relay).
J16 IN connector for XNet2 (SDTI network 1485Mbps without relay).
Gigabit Connectors
The two board Gigabit connectors are connected to the two backplane Gigabit ports.
The Gigabit connectors must be on a network that supports Jumbo Frames of (at least)
9014 bytes Ethernet frames. One of the tested switch belongs to the Cisco 3750 G family,
for example the WS-C3750G-24T-S.
For more information, refer to the Multicam Configuration manual for setting up the IP
addresses.
6.4.2. RCTL Board on SAS Disk Array
Disk Arrays on systems with H3X boards have a controller on the disk array board.
Different configurations can be used
• One internal array with a series of 6 disks
• One internal arrays with two stacked series of 6 disks,
• No internal storage
78 6. Boards Description
EVS Broadcast Equipment S.A. -November 2011 Issue 11.00.A