EVS XS - Page 84

LEDs on Internal Array
LEDs 1 to 6 are used in case of one internal array of 6 disks.
LEDs 7 to 12 are used for the upper series of disks in case of one internal array of 2x6
disks.
LEDs correspond to the disks as schematized as followed:
upper 7 12
lower 1 6
upper 8 9 10 11
lower 2 3 4 5
LED Status Function
Disk
LEDs
off the corresponding disk is not started (not spinning)
on, fast blinking
(green)
the corresponding disk is starting (spinning)
on, steady (green) the corresponding disk is started and used in the RAID
array
on, slowly blinking
(green)
the corresponding disk is started but not used in the RAID
array
STS on (green) the RCTL RAID controller is properly booted.
ERR on (red) errors occur during the data transfer between the RAID
controller and the disks
XS Server-Version 11.00-Hardware Technical Reference Manual
6. Boards Description 79