EVS XS - Page 86

LEDs on the External Array
For each disk, a blue LED and a red LED are present.
Status
Function
Blue
Led
Red Led
Off On (steady) Defect drive – must be replaced.
Blinking Off Connected, disk being written to / read from.
On
(steady)
Off Connected, disk not currently written to / read from.
On
(steady)
On, slowly
blinking
Spare disk - the corresponding disk is started and used in the
RAID array.
Off Off The corresponding disk is not present.
Note
When starting from a clean disk array (after a “Clear Video Disks” from the EVS
maintenance menu), the server is recording first on RAID #0 until this one is full,
then on RAID #1 and finally on RAID #2. It is therefore normal to see activity
only on some disks depending on how much material (clips and record trains) is
stored on the server.
Sound Alert on External Array
When a fan or a power supply unit fails on an external array, a sound alert is given and can
be stopped by pressing the Mute button on the array.
XS Server-Version 11.00-Hardware Technical Reference Manual
6. Boards Description 81