EVS XS - Installation; Safety, Compliance and Operating Conditions; Safety; EMC Standards

XS Series DISK RECORDER - Version 10.03 - Hardware
Technical Reference Manual
Issue
10.03.B
EVS Broadcast Equipment SA
–
March 2010
5
1.4 INSTALLATION
Before turning on the power, open the front door of Video disk recorder unit to
check if all boards fit into their guides. If a board is out of its guides, remove
carefully the board and replace it in the same slot.
1.5 SAFETY, COMPLIANCE AND OPERATING
CONDITIONS
1.5.1 SAFETY
This equipment has been designed and tested to meet the requirements of the
following:
EN 60950
European Safety of information technology equipment
including business equipment.
IEC 950 International Safety of information technology equipment
including business equipment.
In addition, this equipment has been designed to meet the following:
UL 1950 - USA USA Safety of information technology equipment
including business equipment
1.5.2 EMC STANDARDS
EN 55022 European Emission Standard
EN 61000-3-2 European Electromagnetic Compatibility (EMC) Part 3 (Limits);
Section2 ; limits for harmonic current emissions
(equipment input current <16A per phase)
EN 61000-3-3 European European Electromagnetic Compatibility (EMC) Part
3 (Limits), Section 3; limitation of voltage fluctuation
and flicker in low-voltage supply systems for
equipment with rated current of 16 A.
EN 61000-4-3 European European Electromagnetic Compatibility (EMC) Part
4 (Limits), Section 3; Testing and measurement
techniques - Radiated, radio-Frequency,
electromagnetic field immunity test.
EN 61000-4-4 European European Electromagnetic Compatibility (EMC) Part
4 (Limits), Section 4; Testing and measurement
techniques - Electrical fast transient/burst immunity
test.