EVS XS - Hardware Installation and Cabling

Issue
10.03.B
XS Series DISK RECORDER
–
Version 10.03
- Hardware Technical Reference
EVS Broadcast Equipment SA
–
March 2010
36
2.7 CONNECTING MULTIPLE EVS VIDEO
SERVERS ON XNET
The XNet network may be composed by several EVS video servers all connected
with a 75-Ohm coaxial cable (BNC).
The exchange between systems is operated through the SDTI interface at 540 or
1485 Mbps.
On XS servers there is one pair of SDTI connectors: XNet[2] Non-Relay
connectors that can be used at 540 or 1485 Mbps.
The SDTI loop is closed only when the Multicam software is started. It is therefore
recommended to use XHub when using Non-Relay connectors to avoid network
interruptions.
Note
If an XS ‘SAS’ must be connected to other XT2 or XS servers with SCSI
disks, these servers must run at least Multicam version 10.01.67.
2.7.1 CONNECTION DIAGRAM WITHOUT EVS XNET HUB