EVS XS - Connectors; Gigabit Connectors

XS Series DISK RECORDER - Version 10.03 - Hardware
Technical Reference Manual
Issue
10.03.B
EVS Broadcast Equipment SA
–
March 2010
57
Note
When booting the HCTX board, LEDs 1 to 8 will light according to the
following sequence :
Hardware reset
Æ
all LEDs on (1 : red ; 2
to 7 : green)
Setup of CPU basic
registers
Æ
LED 2 on (green)
Check of CPU/PC
DPRAM
Æ
if error: LED 1 on (red)
+ LED 8 on (green)
Æ
if check is successful:
LED 3 on (green)
Polling for PC
commands
Æ
LED 4 on (green)
Switching to enhanced
mode
Æ
LED 5 on (green)
Executing PC
commands until
execution requests end
LED 6 on (green)
Jump to SDRAM and execute microcode
CONNECTORS
On the XNet[2] module (SDTI) :
J5: OUT connector for XNet[2] (SDTI network 540/1485Mbps without relay).
J6: IN connector for XNet[2] (SDTI network 540/1485Mbps without relay).
GIGABIT CONNECTORS
The two Gigabit connectors of the card are connected to the two Gigabit ports of
the backplane.
The Gigabit connectors must be on a network that supports Jumbo Frames of (at
least) 9014 bytes Ethernet frames. One of the tested switches belongs to the
Cisco 3750 G family, for example the WS-C3750G-24T-S.
For more information, refer to the Multicam Configuration manual for setting up
the IP addresses.