EN
IMPORTANT SAFETY INSTRUCTIONS WARNING!
.1..
This
product
should only
be
installed, repaired
or
maintained
by
authorized
electricians
and
in
accordance
with national guidelines for electrical
installations.
All
applicable
local, regional
and
national regulations for electrical
installations
must
be
respected .
.I..Regularly check
if the charger has visible
damage.
Do
not
use a
damaged
product.
.I..Make sure
that
all safety facilities
and
connections are available, properly
installed
and
undamaged
at
all
times
and
are
tested regularly
to
ensure
they
can
operate normally .
.I..Make sure
that
the input voltage, frequency, circuit breakers
and
other
conditions
of
the device
meet
the
specifications before the
device
is
powered
on.
lt's
important
to
observe
the
maximum
permissible charging current of the
connection .
.&.Before
powering on
the
device, please confirm
that
the
device
is
properly
grounded
to
avoid unnecessary accidents. lf a ground fault occurs, it
is
assumed
that
the
cable
carries voltage. Please make sure there
is
no
high-voltage
power
in
the
system before inspecting
the
device .
.&.Please
insulate
the
unnecessarily exposed metal parts of all tools to prevent
them
from
touching the
metal
frame, which
may
cause short circuit.
.&.
To
ensure
the
service life
and
stable operation of the charging station,
the
operating environment should
be
kept as clean as possible with a relatively
stable
temperature
and
humidity.
The
charging station must
not
be
used
in
flammable
environment or environments with volatile gas .
.&.Please
keep
the
power
cord
away
from
the
heated suriace. Please
do
not
put
the
power
cord
in
the
gap
of the closed
door
or pull it
out
of sharp edges or
corners .
.&.Do
not use the chargerwhen the inside of the charging plug
is
wet.
.&.Do
not
modify, retrofit, or
change
any
part
by
yourself
under
any
circumstances .
.&.Please
do
not
use this
product
as a toy. Please take
good
care
of children
to
ensure
that
they will
not
play with this device as a toy nor
put
fingers into the
charging
connector
when
the
power plug
is
still connected .
.&.
The
circuit
to
which
the
charger
is
to
be
connected
must
be equipped with a
residual current circuit breaker.
.A.NOTE
Please
do
not
use it for other purposes except electric
car
charging.
Do
not
try
to
disassemble
the
device
by
yourself under
any
circumstances.
Otherwise, the internal precision parts
may
be
damaged,
and
you will
not
be
able
to
apply
for after-sales service.
To Next Page
Loading...