EWS OS 3030 - Activating Buzzer Signals; Buzzer Activation Configuration

OS3030 Changing and Scanning the Basic Values
7. Output function parameters, 8. Activating the buzzer
28
Activation of alarm signal 2
Other events which
should trigger off the
alarm relay.
Press INFO to see the meaning of the abbreviation in plain text.
LP = Low-pressure CO = Concentrate control
ST = Stop signal is active EP = Exceeded pressure control
Activation of alarm signal 3
Other events which
should trigger off the
alarm relay.
Press INFO to see the meaning of the abbreviation in plain text.
PF = Power failure MT = Maintenance required
EX = External switch PS = Motor circuit-breaker has been activated
8. Activation of the buzzer
Buzzer
Activation of the buzzer 1
Warning: You can only
select the options for
which limits have been
set, an input function se-
lected or appropriate input functions chosen in the previous programming
steps. (Except for the motor circuit-breaker selection; this is always dis-
played).
In this and in the subsequent two steps, program the events which should
trigger off the buzzer.
Press INFO to see the meaning of the abbreviation in plain text.
MI = Value < min. conductivity limit EM = Tank is empty
MA = Value > max. conductivity limit FU = Tank is full
Activation of the buzzer 2
Other events which
should trigger off the
buzzer.
Press INFO to see the meaning of the abbreviation in plain text.
LP = Low-pressure CO = Concentrate control
ST = Stop signal is active EP = Exceeded pressure control
Activation of the buzzer 3
Other events which
should trigger off the
buzzer.
Press INFO to see the meaning of the abbreviation in plain text.
PF = Power failure MT = Maintenance required
EX = External switch PS = Motor circuit-breaker has been activated
S t e p n o . : 7 . 1 0
L P | S T -
S t e p n o . : 7 . 1 1
P F - P S | E X -
S t e p n o . : 8 . 1
M I | M A | E M - F U -
S t e p n o . : 8 . 2
L P | S T -
S t e p n o . : 8 . 3
P F - P S | E X -