NLFR PLEN SVDE
1
supervised when in the vicinity of
the product whether it is working or
use this heater if it has
use if there are visible
: Use this heater on a
use the heater on deep pile
carpets or the long hair type of rugs,
or less than 750mm (30”) away
from any overhanging surface.
Keep combustible materials such
as drapes and other furnishings
clear from the front, sides and rear
of the heater. Do not use heater to
: Do not use this heater
in small rooms when they are
occupied by persons not capable
of leaving the room on their own,
unless constant supervision is
TKܪWJ
keep textiles, curtains or any other
RNSNRZR
distance of 1m from the air outlet.
GJQTSLX YT
the appliance and must be kept in a
safe place. If changing owners, the
YMJ
SPECIFICATIONS
Model QUBE2MB
EAN code 3 461 710 000 013
Power 2000 W
Thermostat Electromechanical
Heat Settings 2 : 800W / 2000W
Fan Mode Yes
Handle Yes, leather effect
Overheat protection Yes
Anti-tilt protection Yes
Voltage 230-240V~
Frequency -_
Product dimensions (WxDxH) W25.1 x D14.9 x H28.9 cm
Product weight 1.7 kg
ELECTRICAL CONNECTION
4SQ^UQZLYMJFUUQNFSHJTSYTF[TQYFQYJWSFYNSLHZWWJSYUT\JWXZUUQ^WJXUJHYYMJNSINHFYNTSXTSYMJNIJSYNܪHFYNTS
plate) and to an electrical installation which complies with the relevant standards. Please read the safety and installation
instructions carefully prior to switching the appliance on.
INSTRUCTION FOR USE
Heat control – Switch Knob (See 2, Fig. 1)
OFF
Cool Blow*
Half Heat
Full Heat
Thermostat control knob (See 3, Fig. 1)
The heat output is controlled by the thermostat.
Turn the thermostat knob fully clockwise to maximum setting initially. When the room is warm
enough, reduce the setting slowly until the heater just clicks off.
The heater will now cycle on and off to maintain your selected room temperature.
An audible click may be heard when the thermostat operates - this is normal.
Note: If the heater does not come on when the thermostat is at a low setting, this is normally
because the room is warmer than the thermostat setting and is not a fault.
When the heat control is set to
for cool blow, set the thermostat control (3) to maximum.
Position will turn the heater on and off to maintain a temperature of approximately 5°.
Arrêt
Air frais*
Mi-chauffage
Plein chauffage
Qube2MB_A5_ZW.indd 1 20/07/20//30 16:01
To Next Page
Loading...
