Exmark Turf tracer HP User Manual

- 24 -
WARNING
POTENTIAL HAZARD
♦ The engine can become very hot.
WHAT CAN HAPPEN
♦ Touching a hot engine can cause severe burns.
HOW TO AVOID THE HAZARD
♦ Allow the engine to cool completely before service or
making repairs around the engine area.
5.1.1 Check engine oil level.
Service Interval:
See Engine Owner's Manual
a) Make sure mower is on a level surface. Stop engine and wait for all
moving parts to stop.
b) Check with engine cool.
c) Clean area around dipstick. Remove dipstick and wipe oil off. Reinsert the
dipstick (
DO NOT
screw into place for Kohler and Kawasaki engines;
DO
screw into place for B&S engines). Remove dipstick and check oil level.
d) If the oil level is low, add oil as specified in the Engine Owner’s Manual to
bring the oil level up to the “F” mark on the dipstick.
DO NOT OVERFILL
.
IMPORTANT:
DO NOT
operate the engine with oil level below the “L”
mark or over the “F” mark.
5.1.2 Clean engine air cooling system.
Service Interval:
See Engine Owner's Manual
a) Stop engine and wait for all moving parts to stop. Remove ignition key or
spark plug wire(s).
b) Clean all debris from engine air intake screen and from around engine
shrouding.
5.1.3 Clean grass build-up under deck and check mower blades.
Service Interval:
Daily
CAUTION
POTENTIAL HAZARD
♦ Raising the mower deck for service or maintenance
relying solely on mechanical or hydraulic jacks could
be dangerous.
WHAT CAN HAPPEN
♦ The mechanical or hydraulic jacks may not be enough
support or may misfunction allowing the unit to fall,
which could cause injury.
HOW TO AVOID THE HAZARD
♦ DO NOT rely solely on mechanical or hydraulic jacks
for support. Use adequate jack stands or equivalent
support.

Exmark Turf tracer HP Specifications

General

Brand	Exmark
Model	Turf tracer HP
Category	Lawn Mower
Language	English