- 26 -
d) If machine does not pass any of these tests,
DO NOT
operate. Contact
your authorized
EXMARK SERVICE DEALER.
IMPORTANT: It is essential that all Operator Safety Mechanisms, be in
place and in proper operating condition prior to mowing.
5.1.5 Check for loose hardware.
Service Interval:
Daily
a) Stop engine and wait for all moving parts to stop. Remove ignition key or
spark plug wire(s).
b) Visually inspect machine for any loose hardware or any other possible
problem. Tighten hardware or correct the problem before operating.
5.1.6 Service pre-cleaner element and air cleaner.
Service Interval:
See Engine Owner's Manual
5.1.7 Change engine oil.
Service Interval:
See Engine Owner's Manual
NOTE: Change oil after first five (5) hours of operation. Follow engine
manufacturers recommendations for future oil changes.
a) Disengage blade clutch.
b) Stop engine and wait for all moving parts to stop. Remove ignition key or
spark plug wire(s).
c) Drain oil while engine is warm from operation.
d) Remove the oil drain plug from the right hand side of the engine. (For
electric start units, the oil drain plug is located on the left hand side of the
engine). Allow oil to drain, then replace drain plug.
e) Replace the oil filter as per Engine Owner's Manual. Clean around oil
filter and unscrew filter to remove.
Before reinstalling new filter, apply a thin coating of oil on the surface of
the rubber seal. Turn filter clockwise until rubber seal contacts the filter
adapter then tighten filter an additional 2/3 to 3/4 turn.
f) Clean around oil fill cap and remove cap. Fill to the specified capacity and
replace cap. Use oil as specified in Engine Owners Manual.
Do not overfill.
g) Start the engine and check for leaks. Stop engine and recheck oil levels.
5.1.8 Check hydraulic oil level.
Service Interval:
40 hr.
a) Stop engine and wait for all moving parts to stop.
b) Clean area around hydraulic reservoir cap and remove cap. Oil level
should be to the top of the baffle inside the tank. If not, add oil.