22
TWILIGHT SERIES MOUNTS
with the interior wall of the dovetail holder. Slide the dovetail plate that is connected to
your telescope into position and firmly retighten the screws. A second telescope can be
mounted on the other side using the same process.
Moving the Mount
The head mount has two large dials that control the vertical (altitude) and horizontal
(azimuth) movement of any mounted telescopes. To move the telescope(s)
up and down, loosen the dial on the top, find your desired position and retighten the
dial. To move the telescope(s) side to side, loosen the dial on the side, find your desired
position and retighten the dial.
Normally, both sides of the head mount share the same angle. However, if you would
like to change the angle on one without affecting the other, use a 3mm hex wrench to
loosen (not remove) the screws on one arm. Gently rotate the arm to your desired angle,
and retighten the screws.
To Previous Page
Loading...