Extreme Networks BlackDiamond 8800 Series - Chapter 11: Installing Blackdiamond Series Modules; Module Slot Assignments

Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
173
11 Installing BlackDiamond Series Modules
This chapter provides important safety information and correct installation procedures for the MSMs
and I/O modules in the BlackDiamond 8800 series switches, BlackDiamond 12800 series switches, and
BlackDiamond 10808 switches. All module types are hot-swappable.
The chapter includes the following sections:
● Module Slot Assignments on page 173
● Distinguishing a BlackDiamond 8800 or 12800 MSM from an I/O Module on page 174
● Installing a BlackDiamond 8800 or 12800 Series Module on page 175
● Connecting and Disconnecting Cables on the 10G4Ca Module on page 178
● Installing a BlackDiamond 10808 Series Module on page 179
● Installing a Backup MSM on page 182
● Verifying the Module Installation on page 182
● Removing a BlackDiamond 8800 or 12800 Series Module on page 183
● Removing a BlackDiamond 10808 Series Module on page 184
● BlackDiamond Series Blank Front Panels on page 185
NOTE
Read the information in this chapter thoroughly before you attempt to install or remove an 8800 series MSM or I/O
module.
CAUTION
Do not attempt to mix modules across Extreme Networks product lines. BlackDiamond 8800 series modules are for
use only in a BlackDiamond 8810 or 8806 switch. Blackdiamond 12800 series modules are for use only in a
BlackDiamond 12804 or 12802 switch. When a BlackDiamond switch is in use, ExtremeXOS software will not
recognize a module from a different product line.
Module Slot Assignments
The specific slot locations for I/O modules and MSMs in the chassis are as follows:
● BlackDiamond 8810 switch:
■ Slots 1, 2, 3, 4, 7, 8, 9, and 10 must have I/O modules.
■ Slot 5/A must have an MSM.
■ Slot 6/B can have an MSM or I/O module.
● BlackDiamond 8806 switch:
■ Slots 1, 2, 5, and 6 must have I/O modules.
■ Slot 3/A must have an MSM.
■ Slot 4/B can have an MSM or I/O module.