Extreme Networks BlackDiamond 8800 Series - Page 176

Installing BlackDiamond Series Modules
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
176
CAUTION
To prevent ESD damage, hold the module by the metal rail and front panel only. Never touch the components on
the PCB or pins on any of the connectors.
5 Verify that the module injector/ejector handles are open (Figure 104).
Figure 104: Injector/ejector handles in an open position
6 Keep the injector/ejector handles in the open position as you slide the module into the chassis slot.
CAUTION
Do not slide the module into the open chassis slot if the injector/ejector handles are in the latched position.
7 Use both hands to latch the injector/ejector handles, by simultaneously pushing both handles
toward the center of the module as shown in Figure 105.
Figure 105: Injector/ejector handles shown in the latched position
CAUTION
There are two styles of ejector/injector handles on the BlackDiamond 8800 and 12800 series modules. Pay careful
attention to the instructions in the next step.
EX_123
EX_124