Extreme Networks BlackDiamond 8800 Series - Summit X250 E-48 T Switch Front Panel; Summit X250 E-48 T Switch Rear Panel

Summit Family of Switches
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
246
NOTE
For information about mini-GBICs, see “Mini-GBIC Interfaces” on page 338.
● Two high-performance stacking ports with associated LEDs
● Redundant power input connector for use with the EPS-160 External Power Module. When this
power supply unit is used with the Summit X250e-48t switch, the power supplies (internal and
redundant) are fully fault tolerant and load-sharing. If one power supply fails, the other power
supply will provide sufficient power to operate the switch.
Summit X250e-48t Switch Front Panel
Figure 171 shows the front panel of the Summit X250e-48t switch.
Figure 171: Summit X250e-48t switch front panel
The front panel on the Summit X250e-48t switch includes:
● LEDs—For a description of the LEDs and their operation, see “Summit X250e Series Switch LEDs”
on page 250.
● Stack number indicator—Numeric indicator of the position of this switch in a stacked configuration.
● 10/100BASE-T Ethernet ports—Forty-eight 10/100BASE-T Ethernet ports that deliver high-density
copper connectivity.
● Combination ports—Two combination ports that provide 10/100/1000 BASE-T or mini-GBIC
connectivity for 2 Gbps of copper or fiber connectivity.
● Console port—Serial port used to connect a terminal and perform local management.
Summit X250e-48t Switch Rear Panel
Figure 172 shows the rear panel of the Summit X250e-48t switch.
SH_044A
10/100 Mbps ports Console
port
Shared ports
Stack number indicator