EPS-600LS External Power Module
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
333
2 Slide the unit completely into the chassis until the front of the EPS-600LS is flush with the surface of
the EPS-C (see Figure 236).
3 Tighten the two captive screws on the EPS-600LS unit into the EPS-C (see Figure 236). This secures
the unit in place.
Figure 236: Securing the EPS-600LS to the EPS-C chassis
4 Connect the AC power cord to the AC connector on the EPS-600LS unit (see Figure 237).
5 Use the cable clip on the EPS-600LS unit to hold the AC power cord in place (see Figure 237).
The EPS-600LS unit does not have a switch for turning the unit on and off. Disconnect power to the EPS-600LS
unit by removing the plug from the electrical outlet. Make sure that this connection is easily accessible to you.
EPS-C_05A
! See Manual
O.T.P
DC OK
AC OK
EPS-600LS
Tighten Screws
To Next Page
Loading...
