Extreme Networks BlackDiamond 8800 Series - G48 P I;O Module; G48 T I;O Module

I/O Modules
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
59
G48T I/O Module
Figure 22 shows the G48T I/O module.
Figure 22: G48T I/O module
The G48T I/O module has 48 autosensing 10/100/1000BASE-T ports that use standard RJ-45
connectors.
The default configuration of the G48T I/O module is as follows. All ports:
● Are added to the default VLAN as untagged
● Inherit the properties of the default VLAN (for example, protocol type and VLANid)
● Operate in autonegotiation mode
The G48T I/O module has the following LEDs:
● Module status
● Module diagnostics
● Port status
For information about the LEDs and their activity on the G48T I/O module, see “I/O Module LEDs” on
page 66.
G48P I/O Module
Figure 23 shows the G48P I/O module.
Figure 23: G48P I/O module
Module status LEDs
10/100/1000BASE-T
ports
ASP037A
Module status LEDs
10/100/1000BASE-T
PoE ports
ASP039A