BlackDiamond 8800 Series Switches Hardware Installation Guide
123
Figure 80: Captive Screw on a BlackDiamond 8000 Series Blank Front Panel
3 Remove the blank front panel from the front of the BlackDiamond switch (see Figure 81).
Figure 81: Removing a Blank Front Panel from a BlackDiamond 8800 series Switch
4 Install an I/O module or MSM in the open slot as described in “Installing a BlackDiamond 8000
Series Module” on page 113.
Leave the ESD-preventive wrist strap permanently connected to the switch, so that the strap is always
available when you need to handle ESD-sensitive components.
To Next Page
Loading...
