BlackDiamond 8800 Series Switches Hardware Installation Guide
135
CHAPTER
9
BlackDiamond AC Power Cord
Retainers
The AC power cord retainers for BlackDiamond 8800 series switches hold the power connectors in the
power sockets and prevent accidental disconnection due to earthquakes, vibration, or other
disturbances.
This chapter includes the following sections:
● BlackDiamond 8810 AC Power Cord Retainer on page 135
● BlackDiamond 8806 AC Power Cord Retainer on page 138
These BlackDiamond switches do not have a switch for turning the power of the unit on and off. Power to
the switch is disconnected by removing the wall plug from the electrical outlet. Always be sure that all plugs and
electrical outlets are easily accessible.
BlackDiamond 8810 AC Power Cord Retainer
Connect all AC power cords before you install the power cord retainer.
You need a #2 Phillips screwdriver to install or remove the AC power cord retainer:
Installing the BlackDiamond 8810 AC Power Cord Retainer
To install the BlackDiamond 8810 AC power cord retainer:
1 Identify the power outlets on the front of the BlackDiamond 8810 switch (see Figure 90).
Figure 90: Power Outlets on the BlackDiamond 8810 Switch
To Next Page
Loading...
