BlackDiamond PSU Covers
BlackDiamond 8800 Series Switches Hardware Installation Guide
142
BlackDiamond 8806 PSU Cover
The BlackDiamond 8806 PSU cover fits onto the AC power cord management bracket and snaps
into place on the front of the BlackDiamond 8806 switch. The PSU cover kit includes the following
parts (Figure 99):
● PSU cover
● AC power cord management bracket with captive retaining screws
Figure 99: BlackDiamond 8806 PSU Cover Kit
Installing the BlackDiamond 8806 PSU Cover
To install the PSU cover:
1 If necessary, remove the installed AC power cord retainer.
2 Make sure that all required AC power cords are connected to the AC power input connectors on the
switch.
3 Attach the AC power cord retainer to the switch:
a Place the retainer against the front of the switch as shown in Figure 100. Make sure that the
retainer engages all the power cord connectors.
b Align and tighten the captive retaining screws.
To Next Page
Loading...
