Extreme Networks BlackDiamond 8810 - Removing the Fan Tray

Replacing BlackDiamond 8800 Series Chassis Components
BlackDiamond 8800 Series Switches Hardware Installation Guide
156
Removing the Fan Tray
To remove a fan tray from the BlackDiamond 8800 series switch:
1 Locate the captive screws at the top and bottom of the fan tray.
2 Using a #2 Phillips screwdriver, loosen each captive screw (see Figure 112 and Figure 113).
Figure 112: Removing the Fan Tray from the BlackDiamond 8810 Switch
Figure 113: Removing the Fan Tray from the BlackDiamond 8806 Switch
3 Use the fan tray handle to pull the fan tray half-way out from the fan tray slot. This action
disconnects the fan tray from the switch power.
Wait for the fan blades to stop turning before continuing with this procedure.
ASP031A
Fan Tray
Handle
Fan Tray
Captive
Screws (x2)
EX_114
Fan tray
handle
Fan tray
captive
screws (x2)