Repacking a BlackDiamond 8800 Series Chassis
BlackDiamond 8800 Series Switches Hardware Installation Guide
168
7 Set a corner brace at each corner of the chassis, and slide the shipping carton down over the chassis
(see Figure 125).
Figure 125: Placing the Carton over the BlackDiamond 8806 Chassis
8 Insert the clip locks (see Figure 9).
a Using your thumb and index finger, squeeze the prongs together.
b Push the clip lock into place and release the prongs.
Repeat these steps to insert each of the remaining clip locks.
Proper installation of the clip locks is critical for safe shipment of the BlackDiamond 8806 chassis. Make
sure that the clip locks are secure and accurately installed.
To Next Page
Loading...
