Power Supplies for BlackDiamond 8800 Series Switches
BlackDiamond 8800 Series Switches Hardware Installation Guide
56
Specifications
The 700/1200 W AC power supply functions from 90 V to 264 V and 47 Hz to 63 Hz AC Input. Each
power supply provides 700 W to the system if the AC input is in the 110 V low-line output power range
and 1200 W to the system if the AC input is in the 220 V high-line output power range.
More installed power supplies are needed to support the load if the low-line power range is used to
power the switch. The software determines the maximum available power required for the switch and
enables the modules accordingly.
The 700/1200 W AC power supply does not have a switch for turning the unit on and off. Remove the plug
from the electrical outlet to disconnect power to the 700/1200 W AC power supply. Make sure that this connection is
easily accessible.
Make sure that the 700/1200 W AC power supply circuit is not overloaded. Use proper over-current protection, such
as a circuit-breaker, to prevent over-current conditions.
To Next Page
Loading...
