• Mid-mount
The side of the switch has different sets of holes for attaching mounting brackets in
either conguration.
Brackets for a two-post mount are not included in the box with the switch. However,
they can be ordered separately using part number XN-2P-RKMT299.
To attach the switch to a two-post rack, follow these steps:
1. On one side of the switch, attach one of the short mounting brackets to the switch
housing.
a. For a front mount, position the bracket over the holes so that the ange (ear) is
even with the front of the switch, as shown in the gure below:
Figure 26: Attaching a Short Mounting Bracket (Ear): Front of Switch
b. For a mid-mount, position the bracket so that the ange (ear) is positioned
slightly more than halfway between the front and back of the switch, as shown in
gure below:
Two-Post Rack Mount Install the Switch
58 Extreme 7520 Hardware Installation Guide
To Next Page
Loading...