4 Place the back of the AP against the wall with the protruding mounting screw heads fitting through
the keyhole slots on the back of the AP, and slide the AP down until the AP rests on the mounting
screw heads. Figure 9 shows an exploded view of this mounting method.
Figure 9: Mounting the WS-AP3825 to a Flat Wall or Solid Ceiling
5 Plug the Ethernet cable into the RJ-45 port (and plug the power cord into the power port, if
applicable) on the back of the AP.
WS-MBI-DCU01 Mounting Bracket for Drop Ceiling
The optional WS-MBI-DCU01 mounting bracket fits 9/16", 14MM, 15/16", 24MM, 1.5", and 38MM wide drop
ceiling rails. This bracket uses four M3 flat head screws to attach it to the AP3825.
Installation
ExtremeWireless™ WS-AP3825i & WS-AP3825e Installation Guide for version . 20
To Next Page
Loading...
