Extreme Networks ExtremeSwitching VDX 6740 - Installing the 1 U, 1.5 U, and 2 U MID-Mount Kit for Two-Post Racks (XBR-000165, XBR-000175, and XBR-R000292)

3. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb (29 cm-kg).
FIGURE 30 Attaching the rear brackets to the front rack posts
1. Screws, 10-32 x 5/8-in., panhead Phillips 2. Retainer nuts, 10-32
Installing the 1U, 1.5U, and 2U Mid-Mount Kit for
Two-Post Racks (XBR-000165, XBR-000175, and
XBR-R000292)
Use the following instructions to install a xed-port device in a mid-mount conguration in a two-post rack using the 1U, 1.5U, and 2U
Mid-Mount Kit for Two-Post Racks (XBR-000165, XBR-000175, and XBR-R000292).
Observe the following when mounting this device:
• Two people are required to install the device in a rack. One person holds the device, while the other secures the device to the
rack.
• Before mounting your device, review any specic installation and facility requirements in this Hardware Installation Guide.
Installing the 1U, 1.5U, and 2U Mid-Mount Kit for Two-Post Racks (XBR-000165, XBR-000175, and XBR-R000292)
ExtremeSwitching VDX 6740 Hardware Installation Guide
50 9036108-00