4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lbs. (29 cm-kgs).
FIGURE 39 Attaching the rear brackets to a rack
1. Retainer nut, 10-32
2. Rear brackets, right (left side similar)
3. Screw, 10-32 x 5/8-in., panhead Phillips
Attaching the rear brackets to the device
Complete the following steps to attach the rear brackets to the device.
1. Align the right rear bracket to the right rear of the device and using two 8-32 x 5/16-in. screws, attach the bracket to the device
as shown in the following gure.
2. Align the left rear bracket to the left rear of the device and using two 8-32 x 5/16-in. screws, attach the bracket to the device.
Installing the 1U and 2U Flush-Mount Rack Kit for Two-Post Racks (XBR-000307 and XBR-R000293)
ExtremeSwitching VDX 6740 Hardware Installation Guide
60 9036108-00
To Next Page
Loading...
