1. Rear bracket, short or long 2. Screws, 6-32 x 1/4-in., panhead Phillips
Attaching the rear brackets to the front rack posts
Complete the following steps to attach the rear brackets to the front rack posts.
1. Attach the right rear bracket to the right front rack post using two 10-32 x 5/8-in. screws and two retainer nuts, as shown in
Figure 52. Use the upper and lower holes in the bracket.
2. Attach the left rear bracket to the left front rack post using two 10-32 x 5/8-in. screws and two retainer nuts. Use the upper and
lower holes in the bracket.
3. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb (29 cm-kg).
FIGURE 52 Attaching the rear brackets to the front rack posts
1. Screws, 10-32 x 5/8-in., panhead Phillips 2. Retainer nuts, 10-32
Installing the Universal Two-Post Rack Kit (XBR-
R000294)
Use the following instructions to install an Extreme Networks 1U or 2U device in a two-post telecommunications (Telco) rack using the
Universal Two-Post Rack Kit (XBR-R000294).
There are two ways you can mount the device in a two-post rack:
• With the port side ush with the front posts
• With the posts mounted to the mid-section of the device
Installing the Universal Two-Post Rack Kit (XBR-R000294)
ExtremeSwitching VDX 6740 Hardware Installation Guide
74 9036108-00
To Next Page
Loading...
