3. Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lb (17 cm-kg).
FIGURE 57 Attaching the rear brackets to the device
1. Screws, 8-32 x 5/16-in., panhead Phillips
Mid-mounting
Observe the following notes when using this procedure:
• The device must be turned
o and disconnected from the fabric during this procedure.
• The illustrations in this document show a 1U device, but the instructions are the same for a 2U device.
• The illustrations in the rack installation procedures are for reference only and may not show the actual device.
Complete the following tasks to install the device in a rack:
1. Attaching the front brackets to the device on page 80
2. Attaching the front brackets to the rack on page 81
3. Attaching the rear brackets to the rack on page 82
4. Attaching the rear brackets to the device on page 83
Attaching the front brackets to the device
Complete the following steps to attach the front brackets to the device.
1. Position the right front bracket with the at side against the right side of the device, as shown in Figure 58.
Installing the Universal Two-Post Rack Kit (XBR-R000294)
ExtremeSwitching VDX 6740 Hardware Installation Guide
80 9036108-00
To Next Page
Loading...
