OSPF Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1550
configure ospf area normal
configure ospf area <area-identifier> normal
Description
Configures an OSFP area as a normal area.
Syntax Description
Default
Normal.
Usage Guidelines
A normal area is an area that is not any of the following:
● Stub area
● NSSA
Virtual links can be configured through normal areas. External routes can be distributed into normal
areas.
Example
The following command configures an OSPF area as a normal area:
configure ospf area 10.1.0.0 normal
History
This command was first available in ExtremeWare XOS 10.1.
Platform Availability
This command is available on all platforms.
area-identifier Specifies an OSPF area.
To Next Page
Loading...