2. Push and rotate the main mounting bracket on the T-bar in such a way that the center angled
locking tabs of the main bracket gets attached to the T-bar.
Figure 4: Install the main mounting bracket on a T-bar
3.
Place the access point on the bracket feet and slide it down to lock it in place.
Hold the access point and rock it back and forth to ensure that it is securely mounted.
4. Replace the ceiling tiles.
5. Attach the RJ45 connector to the GE1 port.
Install the Access Point
Install the Access Point on a Flat T-bar Using Main
Mounting Br
acket
ExtremeWireless™ AP310i/e Access Points 23
To Next Page
Loading...
