PARTS LIST: ALSO AVAILABLE AT WWW.EXTREMERCBYRSI.COM
SAFETY INSTRUCTIONS
4
Distributed and serviced by: Extreme RC by RSI, Ferndale, MI 48220 P: (586) 757-1336 E: Service@extremercbyrsi.com
USE GOOD COMON SENSE WHEN FLYING!
#
1 Head cover
#
2 Main blades
#
3 Tail blade
#
4
Fuselage housing with
bottom outer shaft
#
5 Landing gear
#
6 Balance bar
#
7
Tailpipe with motor,
fin and tail
#
8
Main inner shaft
with motor gears
#
9 Li-poly battery
#
10
Side support metal
plates
#
11 Tail support bar
#
12 Blade connectors
#
13
Center outer shaft
support cover
#
14
Top shaft center
head cover
#
15
Top blade connector
#
20
Camera / video
#
16 Front motor
#
18
Bottom outer shaft
with blade connector
#
19
Circuit board with
ON / OFF switch
#
21
Photo / Video
download USB wire
#
22 Remote control
#
17 Rear motors
PARTS - SERVICE - REPAIRS
Toll Free: 888-221-8851 Tel: 586-757-1136 x 1
E-mail: Service@extremercbyrsi.com
Website: www.extremercbyrsi.com
OPEN: Mon - Fri 9 AM to 6 PM ... Sat 10 AM to 3 PM (EST)
ENVIRONMENT FOR FLIGHT
Recommended flying area for indoor: 12’L x 12’W x 12’H (3.65 m L x 3.65 m W x 3.65 m H)
Avoid drafts, forced air, water, fans, heat and air conditioning vents.
Keep flying helicopters away from pets, young children, the elderly and the disabled.
WARNING
Do not place stickers, weight, or anything else on the helicopter. This may cause the helicopter to crash or malfunction.
Avoid flying the unit under low ceilings. Crashing into ceilings may cause damage to the helicopter.
To avoid injury, do not touch the blades or any other moving parts.
When not in use (especially for 30 days or more) remove ‘AA’ batteries from remote control unit -
batteries may leak and cause damage.
To Previous Page
Loading...