Installing Optional Features
Consolidated "e" Series Hardware Installation Guide 95
1 Remove the EPS-160 from the packing material.
2 Insert the EPS-160 into the front of the EPS-T.
3 Tighten the provided thumbscrews to secure the power supply to the tray.
4 Follows steps 7 through 9 on page 93.
Removing an EPS-160 from the EPS-T
To remove an EPS-160 from an EPS-T:
1 Disconnect the AC by removing the plug from the wall
2 Disconnect the AC power cord from the EPS-160.
3 Remove the redundant power cable from the EPS-160.
4 Loosen the thumbscrews on the front of the tray and slide the EPS out of the EPS-T.
To Next Page
Loading...
