Extreme Networks Summit 200-24 - Page 120

120 Summit 200 Series Switch Installation and User Guide
Access Policies
config ospf direct-filter [<access_profile> |
none]
Configures the router to use the access policy to
limit the routes that are advertised into OSPF for
the switch as a whole for switches configured to
support direct route re-distribution into OSPF.
config rip vlan [<name> | all ] export-filter
[<access-profile> | none]
Configures RIP to suppress certain routes when
performing route advertisements.
config rip vlan [<name> | all] import-filter
[<access_profile> | none]
Configures RIP to ignore certain routes received
from its neighbor.
config rip vlan [<name> | all] trusted-gateway
[<access_profile> | none]
Configures RIP to use the access list to
determine which RIP neighbor to receive (or
reject) the routes.
create access-profile <access_profile> type
[ipaddress]
Creates an access profile. Once the access
profile is created, one or more addresses can be
added to it, and the profile can be used to control
a specific routing protocol.
Specify the following:
• ipaddress—A list of IP address and mask
pairs.
delete access-profile <access_profile> Deletes an access profile.
show access-profile <access_profile> Displays access-profile related information for the
switch.
Table 31: Routing Access Policy Configuration Commands (continued)
Command Description