Routing Configuration Example
Summit 200 Series Switch Installation and User Guide 187
Routing Configuration Example
Figure 33 illustrates a switch that has two VLANs defined as follows:
• Finance
— Contains ports 2 and 4.
— IP address 192.207.35.1.
• Personnel
— Contains ports 3 and 5.
— IP address 192.207.36.1.
Figure 33: Unicast routing configuration example
In this configuration, all IP traffic from stations connected to ports 2 and 4 have access to the router by
way of the VLAN Finance. Ports 3 and 5 reach the router by way of the VLAN Personnel.
enable ip-option strict-source-route Enables the strict source route IP option.
enable ip-option use-router-alert Enables the switch to generate the router alert
IP option with routing protocol packets.
enable irdp {vlan <name>} Enables the generation of ICMP router
advertisement messages on one or all VLANs.
The default setting is enabled.
unconfig icmp Resets all ICMP settings to the default values.
unconfig irdp Resets all router advertisement settings to the
default values.
Table 55: ICMP Configuration Commands (continued)
Command Description
EW_090
2
Finance Personnel
3 4 5
192.207.36.0192.207.35.0
192.207.36.14
192.207.35.13
192.207.35.11
192.207.36.12
192.207.36.1192.207.35.1
To Next Page
Loading...
