Extreme Networks Summit WM - Resetting the Outdoor AP to Its Factory Default Settings

Performing system maintenance
Summit WM Maintenance Guide, Software Version 5.384
Figure 7: Position of the reset button in the Altitude 350-2 AP
Resetting the Outdoor AP to its factory default settings
All models of the Outdoor AP have a reset button.
You can set the Outdoor AP to its factory default settings by pressing and holding the reset button for
approximately six seconds.
NOTE
If you press the reset button and do not hold it over six seconds, the Outdoor AP will merely reboot, and not reset to
its factory defaults.
The following figure illustrates the location of the reset button on the Outdoor AP.
Figure 8: Position of the reset button with the housing cover removed
AC/DC
P
ower
S
upp
l
y
Ethernet Port
R
ese
t
B
u
tt
on