Network Setup
Summit WM3000 Series Controller System Reference Guide106
Viewing Virtual Interface Statistics
To view detailed virtual interface statistics:
1 Select a virtual interface from the Statistics tab
2 Click the Details button.
3 The Interface Statistics screen displays with the following content:
Name
Displays the title of the logical interface selected.
MAC Address
Displays physical address information associated with the interface. This
address is read-only (hard-coded at the factory) and cannot be modified.
Input Bytes
Displays the number of bytes received by the interface.
Input Unicast
Packets
Displays the number of unicast packets (packets directed towards the
interface) received at the interface.
Input NonUnicast
Packets
Displays the number of NonUnicast Packets (Multicast and Broadcast
Packets) received at the interface.
Input Total Packets
Displays the total number of packets received at the interface.
Input Packets
Dropped
Displays the number of packets dropped at the interface by the input
Queue of the hardware unit /software module associated with the VLAN
interface. Packets are dropped when the input Queue of the interface is
full or unable to handle incoming traffic.
Input Packets Error
Displays the number of packets with errors at the interface. Input Packet
Errors are input errors occurring due to; no buffer space/ignored packets
due to broadcast storms, packets larger than maximum packet size,
framing errors, input rate exceeding the receiver's date handling rate or
cyclic redundancy check errors. In all these cases, an error is reported.
Output Bytes
Displays the number of bytes transmitted from the interface.
Output Unicast
Packets
Displays the number of unicast packets (packets directed towards a single
destination address) transmitted from the interface.
Output NonUnicast
Packets
Displays the number of unicast packets transmitted from the interface.
Output Total Packets
Displays the total number of packets transmitted from the interface.
To Next Page
Loading...