Extreme Networks Summit WM3000 Series

To Next Page

To Previous Page

Network Setup

Summit WM3000 Series Controller System Reference Guide166

NOTE

Configure the secondary NAC server for redundancy.

c Configure the secondary NAC server’s IP address.

WLANController(config-wireless) #wlan 1 nac-server secondary 192.168.1.20

WLANController(config-wireless) #

d Configure the secondary NAC Server’s Radius Key.

WLANController(config-wireless) #wlan 1 nac-server secondary radius-key my secret-2

WLANController(config-wireless) #

3 MUs not NAC authenticated use Radius for authentication. To configure the WLAN’s Radius

settings:

a Configure the Radius server’s IP address.

WLANController(config-wireless) #wlan 1 radius-server primary 192.168.1.30

WLANController(config-wireless) #

b Configure the server’s Radius Key

WLANController(config-wireless) #wlan 1 radius-server primary radius-key my-rad-secret

WLANController(config-wireless )#

c Configure the secondary Radius server’s IP address.

WLANController(config-wireless) #wlan 1 radius-server secondary 192.168.1.40

WLANController(config-wireless) #

d Configure the secondary server’s Radius Key.

WLANController (config-wireless) #wlan 1 radius-server secondary radius-key my-rad-secret-2

WLANController (config-wireless) #

4 Configure the NAC server’s timeout and re-transmit settings. The timeout parameter configures the

duration for which the controller waits for a response from the Radius server before attempting a

retry. This is a global setting for both the primary and secondary server.

The re-transmit parameter defines the number of retries a controller attempts before dis-associating

the MU.

WLANController(config-wireless) #wlan 1 nac-server timeout 30 retransmit 10

WLANController(config-wireless) #

5 Configure WLAN for EAP authentication and define the encryption type.

WLANController(config-wireless) #wlan 1 authentication-type eap

WLANController(config-wireless) #wlan 1 encryption-type wep128

WLANController(config-wireless) #wlan 1 ssid wlan-1

Viewing Associated MU Details

The Mobile Units screen displays read-only device information for MUs interoperating with the

controller managed network. The Mobile Units screen consists of the following tabs:

● Viewing MU Status

Extreme Networks Summit WM3000 Series - Page 166