Extreme Networks Summit WM3000 Series - Page 180

Network Setup
Summit WM3000 Series Controller System Reference Guide180
6 Click the Edit button to launch a screen used to configure radio specific parameters. For more
information, see “Editing AP Settings” on page 182.
7 Click the Delete button to remove a radio. However, before a radio can be removed, the radio’s BSS
mapping must be removed.
8 Click the Add button to add a radio. The radio must be added before the radio can be adopted. For
more information, see “Adding APs” on page 187.
9 Click the Tools > button to displays a submneu with Reset, Run ACS and Export options.
Select the Reset option to reset the Access Point radio. Select the Run ACS Now option to scan all
channels and discover which radios are adopted and on what channel. ACS then analyzes the radios'
channels and moves the radio to the channel where it is least likely to have interference from the
other radios. Use the Export option to move the contents of the table to a Comma Separated Values file
(CSV).
10 When using clustering and the Cluster GUI feature is enabled, a drop-down menu will be available
to select which cluster members’ Access Point radios are displayed. To view Access Point radios
from all cluster members, select All from the drop-down menu. To view Access Point radios from a
specific cluster member, select that member’s IP address from the drop-down menu.
11 Click the Global Settings button to display a screen with settings applying to all radios on the system.
For more information, see “Configuring an AP Radio’s Global Settings” on page 180.
Configuring an AP Radio’s Global Settings
Use the Global Settings screen to define an adoption preference ID for the controller and enable an
option to adopt non-configured radios. This can be helpful when you do not want to change an Access
Point’s configuration but require the Access Point be adopted.
To edit Global Radio configuration settings:
1 Select Network > Access Point Radios from the main menu tree.
2 Click the Configuration tab.
3 Click the Global Settings button to display a screen containing global settings which apply to all
radios on the controller.
4 Set an Adoption Preference ID value between 1 and 65535.