Network Setup
Summit WM3000 Series Controller System Reference Guide202
● And / Or - Use the And/Or drop down list to expand the selection criteria. Up to two selection
criteria are supported.
● Filter Entire Table - Click Filter Entire Table to apply the filtering criteria on the information being
displayed on the screen.
● Turn Off Filtering - Click Turn Off Filtering to turn off filtering and display all information. Use this
button and the Filter Entire Table button to refresh screen contents after making changes to the
filtering criteria.
When filtering is disabled, a message is displayed at the bottom of the screen. Similarly, when
filtering is enabled, the filtering criteria is displayed at the same place on the screen.
Viewing Access Point Adoption Defaults
Use the Access Point Adoption Defaults screen to configure the current radio adoption configurations,
assigning WLANs and security schemes and to review each radio type, as well as the Access Category
that defines which data type (Video, Voice, Best Effort and Background) the radio has been configured
to process. It has the following tabs:
● Configuring AP Adoption Defaults
● Configuring WLAN Assignment
● Configuring WMM
Configuring AP Adoption Defaults
The Configuration tab displays the current radio adoption configuration including radio type, placement,
channel setting and power settings. Many of these settings can be modified (as well as radio’s current
rate settings) by selecting a radio and clicking the Edit button. These settings are the default
configurations when the radios are set to auto-adopt.
To view existing Radio Configuration information:
1 Select Network > Access Point Adoption Defaults from the main menu tree.
2 Click the Configuration tab.
To Next Page
Loading...