Summit WM3000 Series Controller System Reference Guide 213
1 Select Network > Access Point from the main menu tree.
2 Click the Adopted AP tab.
3 Refer to the Adopted AP screen for the following information:
MAC Address
Displays the radio's first MAC address when it is adopted by the
controller.
Model
Displays the model number of the Access Point.
AP Type
Displays the Access Point type.
Serial
Displays the serial number of the Access Point, and is used for controller
management purposes. It is read-only and cannot be modified.
HW Version
Displays the hardware version of the Access Point. This information can
be helpful when troubleshooting problems with the Access Point.
IP Address
Displays the IP address of the adopted Access Point.
Bootloader
Displays the software version the Access Point boots from. This
information can be helpful when troubleshooting problems.
Protocol Version
Displays the version of the interface protocol between the Access Point
and the controller. This information can be helpful when troubleshooting
problems with the Access Point.
Fw Version
Displays the Access Point firmware version at run time. Use this
information to assess whether the software requires an upgrade for better
compatibility with the controller.
Radio Indices
Displays the indices of the radios belonging to the selected Access Point.
These indices are equivalent to a numerical device recognition identifier
(index) for the radio.
To Next Page
Loading...