Summit WM3000 Series Controller System Reference Guide 219
.
To configure the MSTP bridge:
1 Select Network > Multiple Spanning Tree from the main menu tree.
2 Select the Bridge tab (should be the displayed tab by default).
3 Refer to the MSTP Parameter field to view or set the following:
Global MSTP Status
Use the drop-down menu to define MSTP status. The default is Enabled.
Max Hop Count
Displays the maximum allowed hops for a BPDU (
Bridge Protocol Data
Unit)
in an MSTP region. This value is used by all the MSTP instances.
Supported Versions
Displays the different versions of STP supported.
Protocol Version
Displays the current protocol version in use. Available MSTP protocol
versions are:
• forceNonStp
• forceLegacyDot1d
• forceDot1w
• autoDot1s
• unknown
To Next Page
Loading...