Extreme Networks Summit WM3000 Series - Page 224

Network Setup
Summit WM3000 Series Controller System Reference Guide224
Configuring a Port
Use the Port tab to view and configure MSTP port parameters, including enabling/disabling the
spanning tree algorithm on one or more ports (displaying the designated bridge and port/root
information).
To view and configure MSTP port details:
1 Select Network > Multiple Spanning Tree from the main menu tree.
2 Select the Port tab.
The Port tab displays the following information (ensure you scroll to the right to view the numerous
port variables described):
Index
Displays the port index.
Admin MAC Enable
Displays the status of the Admin MAC. Change the status using the
Edit
button. A green check mark indicates the Admin MAC Enable status is
active/enabled.
Oper MAC Enable
This field displays the status of the Oper MAC Enable. You can change
the status using the Edit button. A green check mark indicates the Oper
MAC Enable status is active/enabled.
AutoEdge
AutoEdge Displays whether the port can automatically detect whether it is
an edge port edge port.
Designated Bridge
Displays the ID of the bridge sent the best BPDU received on this port.